.png.jpg)
★★★★★ 4
Not simple, nor easy
Model: SLH20025
I wanted to add sound proof material to the bare metal areas on the floor of my Toyota Tundra. The area behind the front seats had a haphazard application of sound deadening material. There were several complications to the project which may come up in other vehicles.
First is the floor covering which had plastic pillars underneath to support any weight on the cover. The sound deadening material had to be cut out so these pillars would rest on the bare metal of the floor. This required a lot of cutting with a utility knife and at times heavy scissors. The instructions say to make a template before cutting the material and I did this for the driver's side. This doubled the amount of time needed to install it. On the passenger's side I laid the rectangles of material with the backing on and pressed the floor covering onto the material. This showed where the support pillars were, which I then cut out.
Second is peeling the backing off the material. This can be very difficult as the adhesive sticks to it. The backing came off in multiple pieces and sometimes took 5 minutes for one piece. They say to wear gloves when handling the material but this is impossible when trying to get the backing off.
Third is pressing the material onto the metal. The instructions say to use a roller, but this was impossible for the irregular surface I was working on. The hand is the best tool to press the material on.
The material seems to be of high quality and I expect it will reduce the road noise in the cab.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 18, 2025
